Refreshing TSS Table Data in an IMS Control Region

If you use cache buffering to provide faster access to TSS table data, any changes that you make to TSS tables may not take effect until you purge the cache buffers by performing a TSS refresh.

Figure 1. Panel Flow – Refreshing TSS Table Data in an IMS Control Region

GUID-E197DE28-1798-42AC-9C8F-4731A941E806-low.png

Before you begin

A user access profile must give you authority to refresh TSS table data.

You must have previously created or modified one or more TSS tables. See Defining-a-TSS-Table for instructions.

Warning

Refreshing TSS table data during peak periods may cause excessive I/O, excessive CPU utilization, and decreased performance.

To Refresh TSS Tables

  1. Go to the ETA Translate Sub-System panel. From the ETA Main Menu, type 1 in the Selection field and press Enter. The ETA Translate Sub-System panel is displayed.
  2. Type 12 in the Selection field and press Enter. The Refresh Target pop-up window is displayed.
  3. Type the name of the IMSID or group that you want to refresh in the IMSID or Group field and press Enter. The Confirm TSS Refresh pop-up window is displayed.
  4. Type 1 and press Enter to continue with the refresh, or type 2 and press Enter to cancel the refresh. If you type 1, the TSS Refresh Results pop-up window is displayed. Review the results and press F3 to return to the ETA Translate Sub-System panel. If you type 2, the ETA Translate Sub-System panel is displayed.
  5. Press F3 to return to the ETA Main Menu.

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*