Specifying SNAP dump options for system entries

To indicate whether you want to specify SNAP dump options, complete the following steps. If you want to specify these options, you can also indicate the options for SYSOUT information.

  1. The SNAP Dump Options panel shown in Figure 1 is displayed for system entries when you scroll down from the Statistics Options panel (see Specifying-statistics-options).The panel is displayed for Add and Change; the function you are performing is indicated at the top of the panel.

    Figure 1. DPICDS Entry ADD – SNAP Dump Options panel

                          DPICDS Entry ADD - SNAP Dump Options                      
                                                                                   
     Type information.  Then press Enter.                          More:   -        
                                                                   UP  for previous
       Override DP/IMS defaults (optional)                                          
                                                                                   
         Sysout Information                                                         
           Sysout class  . . _   (A-Z, 0-9, *)                                      
           Hold  . . . . . . _   (Y or N)                                           
           JES node  . . . . ________                                               
           Userid  . . . . . ________                                               
                                                                                   
                                                                                  
     Commands:  CANCEL   SAVE                                                       
                                                                                   
                                                                                   
     Command ===> _________________________________________________________________
  2. Specify the following Sysout Information:
    • Indicate the output class to which the SNAP dump should be directed. The default is *.
    • Type Y or N to indicate whether the dump should be held. The default is N. However, if Hold(N) is specified for a class that is defined as Held, the output will be held.
    • If the dump is to be routed to another system or to a printer, indicate the appropriate NODE name.
    • If the dump is to be routed to a user, indicate the appropriate user ID.
  3. Type the SAVE command and press Enter to record the data for this entry. You are returned to the DPICDS Administration panel. See Specifying-selection-criteria-and-process.

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*