Router Options commands

This topic describes router options commands.

The Energizer Commands Router panel lists commands that are used display and set router options.

Related topic

Issuing-Energizer-commands

The following figure shows the Energizer Commands - Router panel:

                            Energizer Commands - Router                        
                                                                              
Connect ________ + or Host ___________________________ Port _____  
Select one of the following Energizer Commands.  Then press Enter.             
                                                                              
__ 1. -Display Router Type(Status)                                             
   2. -Display Router Type(Affinity)                                           
   3. -Set Router Type(Options) Lbmgt(Active)                                  
   4. -Set Router Type(Options) Lbmgt(Inactive)                                
   5. -Set Router Type(Options) Afmgt(Active)                                  
   6. -Set Router Type(Options) Afmgt(Inactive)                                
   7. -Set Router Type(Options) RdbMemb(*)      New Router Member          
   8. -Set Router Type(Affinity) State(Act) Id(*)   Affinity Label. .          
   9. -Set Router Type(Affinity) State(Inact) Id(*)   '        '               
  10. -Set Router Type(Affinity) Id(*) Dest(*)      DataStore Dest. .

To issue a command, perform one of the following actions:

  • Type the number of the command, and press Enter.
  • To issue a command against a specific router member, Affinity Label, or DataStore Destination, enter the information on the lines provided.


 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*