DDFINTV—DDF interval cycle frequency
Use the Modify DDF Interval Cycle Frequency panel or the DDFINTV command to specify the cycle frequency of the DDF error monitor task.
One of the functions of the error monitor task is to check the conversation timeout counter. Use DDFQCTM to make adjustments to the timeout counter. The actual timeout interval for queued conversations depends on both DDFQCTM and DDFINTV.
Modify DDF Interval Cycle Frequency panel
Command ===> _________________________________________________________________
Command: CURRENT
Description . . . . . . . . : DDF INTERVAL CYCLE FREQUENCY
Type the new DDF interval cycle value that you wish to change to. Then press Enter.
DDF Interval Cycle Frequency Parameter
Interval cycle frequency . . _____ (1-300 or delta)
The changes that you make to this element do not take effect until the next time that DDF is started.
Command syntax and parameters
Value | Description |
|---|---|
DB2ssid | Db2 subsystem ID or the name of the Db2 data sharing group to which the command applies. |
opertuneID | OPERTUNE system profile name (if OPERTUNE is running as a started task) or the batch job name (if OPERTUNE is running as a batch job). |
value | Interval cycle frequency (in seconds) of the DDF error monitor task. Specify one of the following values:
|
NORESET | The changes you request remain in effect until the Db2 subsystem is cycled. |
Db2 parameter values
Field | Installation panel | CLIST parameter | ZPARM macro | ZPARM parameter |
|---|---|---|---|---|
Interval cycle frequency | None | SPRMINT | DSN6SPRC | None |