Skip to Content

MSGLIMIT—DISPLAY Command message limit

Use the Modify Display Command Message Limit panel or the MSGLIMIT command to control the maximum number of output messages Db2 will write as a result of a Db2 DISPLAY command. The new value is used immediately.

Modify Display Command Message Limit panel

DDTG DBI1 Modify Display Command Message Limit
Command ===> _________________________________________________________________

 Command: CURRENT
Description . . . . . . . . : MESSAGE LIMIT

Type the new command message limit value that you wish to change to. Then press Enter.

Display Command Parameter
Message limit . . . . . . . ______ (10-32767 or delta)

Command syntax and parameters

image2018-12-24_11-36-57.png

Value

Description

DB2ssid

Db2 subsystem ID or the name of the Db2 data sharing group to which the command applies.

opertuneID

OPERTUNE system profile name (if OPERTUNE is running as a started task) or the batch job name (if OPERTUNE is running as a batch job).

value

Maximum number of output messages Db2 will write as a result of a Db2 DISPLAY command.

  • A numerical value in the range 10–32767
  • A delta value
    Delta values are expressed numerically (+nn or -nn) or as a percentage (+nn% or -nn%). The resulting value must fall in the range 10–32767.

NORESET

The changes you request remain in effect until the Db2 subsystem is cycled.

Db2 parameter values

Field

Installation panel

CLIST parameter

ZPARM macro

ZPARM parameter

Message limit

None

None

None

None

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*

OPERTUNE for DB2 12.1