FileName

The FileName parameter in the [DiagnosticOutput] section specifies the location where the High-speed Apply Engine writes special diagnostic information used by BMC Support in troubleshooting situations. Use this parameter to override the default location for the diagnostic output file.

Related topic

DiagnosticOutput-parameter

Attributes

This parameter has the following attributes:

Attribute

Value

Section

[DiagnosticOutput]

Abbreviation

None

Required?

No

Valid values

A fully qualified data set name or a DD name

Default values

APTDIAG

Usage

High-speed Apply Engine writes output to this file only when a restart occurs and the value of the RestartType parameter is other than None.

You can specify any valid data set or DD name, or a UNIX or Windows file name for the FileName parameter. For more information about specifying file names on different operating systems, see Usage.

You can use a DD statement to allocate and catalog a new data set. The default DD name for the diagnostic output file is APTDIAG.

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*