Skip to Content

SWITCH

SWITCH is a Data Collector command that you can issue only from the system operator console.

SWITCH generates an archive from the currently active log file for the specified output group(s). Writing continues in the log file, and any subsequent archive requests for that archive will copy records from the point at which SWITCH was issued.

Warning

Important

If archiving is not enabled for the logset, the command has no effect.

Syntax of the SWITCH command

GUID-76FA4C8F-E5E0-4952-B754-5E33A0ECA1D0-low.png

Parameter

Description

DCssid

(Required) The subsystem ID of the Data Collector that owns the output group(s) to be switched.

nnn

Specifies the number of the output group for which the archive is to be performed, where nnn is the number of the output group in the range 001–128.

ALL

Specifies that the command is applicable to all output groups owned by the specified Data Collector.

Related topic

Command-and-syntax-reference

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*

BMC AMI Pool Advisor for Db2 13.1