Limited supportBMC provides limited support for this version of the product. As a result, BMC no longer accepts comments in this space. If you encounter problems with the product version or the space, contact BMC Support.BMC recommends upgrading to the latest version of the product. To see documentation for that version, see BMC AMI Log Master for Db2 13.1.

System requirements

Before you install the product, make sure that your environment meets the hardware and software requirements.

Product compatibility matrix

Log Master requires the operating environment described in this topic.

 Db2 support

This version of Log Master supports IBM supported versions of the IBM Db2 subsystem.

System requirements

This version of Log Master supports IBM supported versions of the z/OS system that are active on all systems in the sysplex.

For data migration, Log Master includes versions of the High-speed Apply Engine that run on distributed systems (UNIX and Microsoft Windows) against target databases on either the IBM Db2 for Linux, UNIX, and Windows (LUW) or Oracle.

To use the Log Master online interface, you need ISPF version 3.3 or later.

Setting the MEMLIMIT parameter

The following products and components require above-the-bar memory and might abend if sufficient memory is not available:

  • ALTER
  • BMCSORT
  • Catalog Manager
  • Change Manager
  • CHECK PLUS
  • BMC AMI Copy
  • DASD MANAGER PLUS
  • High-speed Apply Engine
  • LOADPLUS
  • Log Master
  • BMC AMI Recover
  • BMC AMI Recovery Manager
  • REORG PLUS
  • UNLOAD PLUS

In Version 1.10 and later of the IBM z/OS system, the default value for the System Management Facility (SMF) MEMLIMIT parameter is 2 GB. For most jobs, 2 GB should be sufficient. However, if you are processing a large amount of data (especially compressed data) or operating on LOB or XML data, BMC recommends at least 32 GB.

This value is set in member SMFPRMxx in SYS1.PARMLIB. Use any of the following methods if you need to override the default value:

  • Specify the MEMLIMIT parameter in the JCL.
  • Specify REGION=0M in the JCL.
  • Use the SMF IEFUSI exit.

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*