+NGTAUTO2

The +NGTAUTO2 parameter lets you configure a second BMC AMI Utilities Automation routine set for each Db2 subsystem on which you install BMC AMI Utilities. The data set specified in +NGTAUTO2 is concatenated behind the data set specified in NGTAUTO1.

Example

//NGTAUTO DD DISP=SHR,DSN=ngtauto1.data.set
// DD DISP=SHR,DSN=ngtauto2.data.set

Related topic

Global-parameters-UTLPARMS

During BMC AMI Utilities execution, the data set name is allocated to the NGTAUTO DD. If the +NGTAUTO2 parameter contains variables, these are resolved before allocation.

Important

If the +AUTOLOCK(YES) was specified during configuration, you cannot specify the +NGTAUTO1 parameter in the JCL.

The dataSetName can contain the following variables:

Variable	Description
&ATTACH	Db2 group attachment name or Db2 subsystem ID (up to four characters)
&GROUP	Db2 data-sharing group name (up to eight characters) In a non-data-sharing environment, &GROUP contains the Db2 subsystem ID (up to four characters).
&SSID	The Db2 subsystem name or group name specified on the PARM=name attribute
&SUBSTR	See &SUBSTR
&VER	The version (for example, 1310) of BMC AMI Utilities being executed
&VER3	The first three characters of the version (for example, 131) of BMC AMI Utilities being executed
&VER2	The first two characters of the version (for example, 13) of BMC AMI Utilities being executed.
&USER1	The value of the USER1(userVariable) parameter
&USER2	The value of the USER2(userVariable) parameter

Important

For the rules that apply to parameter syntax, see Parameter syntax rules.

+NGTAUTO2

On this page