Limited support BMC provides limited support for this version of the product. As a result, BMC no longer accepts comments in this space. If you encounter problems with the product version or the space, contact BMC Support.BMC recommends upgrading to the latest version of the product. To see documentation for that version, see BMC AMI Command Center for Db2 13.2

Setting Recovery Management options

You can define the default values used in the Recovery Management perspective.

Default time objective values

You can optionally define global backup and recovery target times. 

BMC AMI Command Center

 can use these values to calculate whether performance times will exceed these values.

BMC AMI Command Center uses these values as default values for any new report.

To set the default time objective values

New console
  1. In the Recovery Management perspective, click Options  NW_gear.png.

  2. On the Time Objectives tab, enter the time objective values, as shown in the following table:

    Option

    Description

    Backup Time Objectives (BTO) Target

    Enter a value (hh:mm).

    Recovery Time Objectives (RTO) Target

    Enter a value (hh:mm).

  3. Click OK.
Classic console
  1. In the Recovery Management perspective, click Options  configuration-24.png.

  2. On the Time Objectives tab, enter the time objective values, as shown in the following table:

    Option

    Description

    Backup Time Objectives (BTO) Target

    Enter a value (hh:mm).

    Recovery Time Objectives (RTO) Target

    Enter a value (hh:mm).

  3. Click OK.


Default storage group values

Following installation, the Db2 storage group for a Db2 connection is SYSDEFLT. You can specify a default global storage group for each Db2 connection. BMC AMI Command Center uses this default value whenever a storage group needs to be defined for an object set. 

To set the default Db2 storage group

New console
  1. In the Recovery Management perspective, click Options  NW_gear.png.
  2. In the Options dialog box, select the Storage Group tab.
  3. Select a Db2 connection.
  4. Click NW_pencil_adapt_teal.png.
  5. Select a storage group.
  6. Click OK.
  7. Click OK.
Classic console
  1. In the Recovery Management perspective, click Options  configuration-24.png.
  2. In the Options dialog box, select the Storage Group tab.
  3. Select a Db2 connection.
  4. Click edit-24.png.
  5. Enter the name of the storage group.
  6. Click OK.


Note

You can change this default value in both the Recovery Management options or the Object Set options within the Product Tools perspective.


 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*