+COPYLVL

The +COPYLVL parameter determines the type of copy file that BMC AMI Reorg or BMC AMI Load creates:

  • Partition-level image copy
  • Single table space full image copy that contains all partitions (sometimes known as a DSNUM ALL copy)


Related topics

COPYLVL
DSNUM ALL

Global-parameters-UTLPARMS

COPYLVL_parm.png

Valid parameter values are as follows. For the rules that apply to parameter syntax, see Parameter syntax rules.

PART

(Default) Creates partition-level image copies.

FULL

Creates a single full image copy that contains all partitions.

If you specify +COPYLVL(FULL), you can specify only a single range of partitions. If you specify more than a single range, BMC AMI Reorg or BMC AMI Load forces +COPYLVL(PART), creating partition-level image copies for each reorganized partition.

This is not a configuration-only parameter. The default value is specified at installation.

BMC AMI Reorg or BMC AMI Load uses any previously configured value of +COPYLVL or utility JCL specifying +COPYLVL in RRGPARMS unless that configuration is overridden by another configuration in the following order of precedence:

  1. COPYLVL FULL|PART on the BMC AMI Reorg SYSIN command
  2. +COPYLVL in UTLPARMS when specified in a utility job
  3. +COPYLVL in a new or reconfigured BMC AMI Utilities configuration setting

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*