Preparing the Installation System repository
When you start the Installation System, if RTCS:
- Is active on your system, it will be used for the Installation System repository and no additional actions are required to prepare the repository.
Is not installed or active on your systems, the Runtime Component System Not Active panel is displayed:
BMIPRTCS Runtime Component System Not Active
Command ===> _______________________________________________________________________
The Runtime Component System (RTCS) is not active on this system. The BMC
Software Installation System requires that RTCS be active. The data entered
while installing products is stored in a repository hosted by RTCS. If RTCS is
not installed you can choose to run a bootstrap version.
Select one of the following actions:
__ 1. RTCS was installed and has now been started
2. Setup a bootstrap version of RTCS
3. Exit the installation system
Regardless of the action selected, the Installation System will terminate and
after RTCS is active, you will be able to access the Installation System.In this case, use one of the following procedures to prepare the Installation System repository:
For information about managing a bootstrap RTCS, see Managing-the-bootstrap-RTCS.
Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*