Skip to Content

SHUTDOWN

Use the SHUTDOWN command to terminate inactive XIM initiators and XIM if there are no active sessions between XIM and a BMC Software product. A utility product may be connected to XIM and not have any active initiators on that MVS image because the UOWs were shipped to an XIM on another MVS image. In this case, no active initiators would appear for the MVS image. You can issue the QUIESCE NEW command to allow all currently active work to terminate normally before XIM terminates.

Syntax of the SHUTDOWN command

image2019-1-4_13-10-26.png

Information
Examples

  • The following example shows the normal termination of an XIM subsystem. If active sessions exist between XIM and a BMC product or XIM initiators are active, the XIM SHUTDOWN command does not perform an orderly or immediate shutdown of XIM and all initiators. In this case you must issue the QUIESCE NEW command to allow all active work to terminate normally before XIM terminates.

    F ximstc,SHUTDOWN
    BMC95100I XIM SHUTDOWN Command Accepted, XIM SHUTDOWN in progress ximstc
    IEF404I ximstc - ENDED - TIME=12.36.13
    $HASP395 ximstc ENDED

  • The following example shows the normal termination of an XIM subsystem with active sessions.

    F ximstc,SHUTDOWN
    BMC95196I XID Command SHUTDOWN ignored, XID is not dormant ximstc


Related Topic

XIM-commands

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*

Common mainframe infrastructure 2018 release