Out of support This documentation supports the 8.0 version of BMC Atrium Single Sign-On, which is in "End of Version Support." However, the documentation is available for your convenience. You will not be able to leave comments.Click here to view the documentation for a supported version of Remedy Single Sign-On.

Configuring the LDAP module

The configuration and use of the LDAP module is described for a single BMC Atrium Single Sign-On server. By default, a single LDAP module is created and configured as part of the LDAP chain. The LDAP module must be configured for the enterprise environment.

To configure the LDAP module

  1. Navigate to Access Control > BmcRealm link > Authentication
  2. Select the Module Instances link.
  3. Click the LDAP link.
  4. Enter your LDAP configuration parameters and click Save.

LDAP configuration parameters

LDAP configuration parameters are entered on the LDAP Realm Attributes page.

The LDAP page has the following options:

  • Save to save your modifications.
  • Reset to remove your modifications and stay on the LDAP page.
  • Back to Authentication to navigate back to the Authentication tab.

Where to go from here

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*