Skip to Content
Information
Unsupported content This version of the product has reached end of support. The documentation is available for your convenience. However, you must be logged in to access it. You will not be able to leave comments.

Analyzing patch configurations and deploying patches

This topic introduces the tasks you must perform when you use the portal to analyze the patch configuration of a server and deploy required patches to correct deficiencies. Each task shown below provides links to related documentation.

Success

Tip

Use Ctrl-click to access the documentation cited in the table below so the related topics appear in new tabs. Displaying information in separate tabs makes it easier to keep this high-level procedure visible.

Task

Related documentation

Using BMC Server Automation, take one of the following steps:

  • Set up a patch catalog that contains patches you want to analyze.
  • Define a Patching job that checks servers for a set of patches.

Using the portal, create a Patch Analysis operation based on the job or the patch catalog you created in the previous step. Use targets already defined for the job or identify new targets.

Execute the Patch Analysis operation.

Examine the results of the Patch Analysis operation.

For targets that still require additional patches, run remediation jobs to deploy missing patches. You can:

  • Deploy all missing patches to all unpatched servers
  • Deploy all missing patches to one server
  • Deploy a single missing patch to all servers requiring that patch
  • Deploy a single patch to a single server (Windows only)

Repeat the initial Patch Analysis operation and check the results of the operation to confirm that targets are correctly patched. Optionally, you can examine the history of the operation to determine whether you are achieving a satisfactory level of correctly patched servers.

Information

For additional overview information that introduces patching, see Walkthrough: Updating patches on Linux servers.

 

Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*

BMC BladeLogic Portal 2.2