Using the pw cloudTopologyIntegration command

The pw cloudTopologyIntegration command is used to start, stop, configure, set log level, and perform operations on BMC ProactiveNet Central server for cloud consuming.

To use the pw cloudTopologyIntegration command

1. Run the pw cloudTopologyIntegration help command on the BMC ProactiveNet Server to get help on the different usages of the command.
   The following prompt appears:

   Usage 1: pw cloudTopologyIntegration help|on|off|status -a <adaptertype>
   pw cloudTopologyIntegration list
   where
   list command will list child adaptertype specified in CloudAdapter.xml
   -a <adaptertype>    child adaptertype or ALL
   Note: adaptertype must be the same as specified in CloudAdapter.xml.
   eg.
   pw cloudTopologyIntegration on -a <adaptertype>
   pw cloudTopologyIntegration off -a <adaptertype>
   pw cloudTopologyIntegration status -a <adaptertype>
   
   
   Usage 2: pw cloudTopologyIntegration conf -a <adaptertype>
   pw cloudTopologyIntegration conf help -a <adaptertype>
   Command will provide help for adapter conf
   
   where
   -a <adaptertype>    child adaptertype
   Note: adaptertype must be the same as specified in CloudAdapter.xml.
   eg.
   pw cloudTopologyIntegration conf -a <adaptertype>
   pw cloudTopologyIntegration conf help -a <adaptertype>
   
   Usage 3: pw cloudTopologyIntegration exec -a <adaptertype> -op <operation>
   pw cloudTopologyIntegration exec help -a <adaptertype>
   help command will give help for custom command suported by child adaptercloudTopologyIntegration
   where
   -a <adaptertype>        child adaptertype  
   Note: adaptertype must be the same as specified in CloudAdapter.xml.
   -op operation           operation for child adapter mandatory for exec command
   eg.
   pw cloudTopologyIntegration exec -a <adaptertype> -op <operation>
   
   Usage 4: pw cloudTopologyIntegration log -a <appender> -l <loglevel>
   pw cloudTopologyIntegration log list
   where
   list this will list appenders registered for adapter
   -a appender         name of appender specified in list command
   -l loglevel         INFO, DEBUG, TRACE
   eg.
   pw cloudTopologyIntegration log -a <appender> -l DEBUG
   
2. Use the commands as shown in the prompt above.