Setting up XBM to perform snapshot processing
The following tables describe the tasks that you perform and where to find additional information.
Note
Typically, these preparatory tasks are performed only once or sporadically.
Preparing to use XBM for snapshot processing
Step | Reference |
---|---|
Install XBM. | |
Configure security. | |
Start the XBM subsystem and components. | |
Set XBM options. | |
Set up XBM and the PSS component for a data sharing environment (if applicable). |
Performing a software snapshot
Step | Reference |
---|---|
Specify the characteristics of the extended buffer by defining a configuration. | |
Create a snapshot template in a management set to define the cache and snapshot attributes. | |
Activate the configuration and management set to indicate that they are ready to participate in a snapshot. | |
Plan for a point of consistency. | |
Run the utility job. Specify the appropriate syntax in your utility’s job control card, and submit the job. |
Performing a hardware snapshot
Step | Reference |
---|---|
Set up the hardware environment. | |
Set SSI options to configure the SSI component. | Enabling SSI snapshots in SSI options and snapshot templates |
Create a snapshot utilities’ template in a management set to define snapshot attributes. | |
Activate the management set to indicate that the template is ready to participate in a snapshot. | |
Run the utility job. Specify the appropriate syntax in your utility’s job control card and submit the job. | |
Manage the hardware through XBM (if necessary). |
Performing an Instant Snapshot
Step | Reference |
---|---|
Set up the hardware environment. | |
Set SSI options to configure the SSI component. | |
Create and run a BMC utility job that requests the Instant Snapshot. | |
Manage the hardware through XBM (if necessary). |
Monitoring the snapshots
Step | Reference |
---|---|
Review the status of a snapshot job. | |
Display the progress of snapshot jobs through the XBM monitors. |
Comments
Log in or register to comment.