Target selection

This section describes the parameter that is used to set the CICS targets that will make use of a specific CMRSOPT parameter table from the CMRSOPT view.

TARGET=xxxxxxxx

On the CMRSOPT view (not available in the CMRSOPT macro) this parameter identifies the target or targets for which the BBIPARM data is used. At least one target name must be supplied. Additional names can be supplied up to the limit of the CMRSOPT view’s input lines.

The generic characters + and * can be used in a target name as follows:

+ designates the existence of any single character (can be used multiple times in a target name).
* designates the existence of zero or more characters starting from that point (can be used once in a target name).

Note

You can turn on data collection for program timing, session and connection data collection, temporary storage, and transient data queue data with the CMRSOPT view but there are no parameters to perform equivalent functions in the CMRSOPT macro.

Target selection

TARGET=xxxxxxxx

Comments