Single data set considerations

When working with single data sets, consider the following guidelines:
  • You must manually start the archive job when the data set is allocated in the BBI-SS PAS proc.

  • Specify the CMRDETL data set in CMRDTL00 in UBBPARM will avoid recycling the BBI-SS PAS when the data set name is changed.

  • If CMRDETL data archives are not needed, define the data set in CMRDTL00 and specify CONTINUE= YES, STOP= NO, ARCHJCL= NONE, and specify only DSN1. When the data set is full, it will overwrite the data set from the beginning and recording will continue.

  • If CMRDETL data archives are needed, define the data set in CMRDTL00 and specify CONTINUE= YES, STOP= YES, specify DSN1 only, and set ARCHJCL to a proc that only runs CMRPURG (a sample can be found in member CMRSJCL in BBSAMP). When the data set is full, the archive proc will be submitted and recording will stop.

    Enter FST2 QOFF and then FST2 QON to restart recording. When archiving is desired, dual CMRDETL data sets is recommended.

  • Specify ARCHJCL= NONE if STOP= NO in CMRDTL00 for a single CMRDETL data set.

Was this page helpful? Yes No Submitting... Thank you

Comments