Using the CICS TARGET PROFILE SELECTION panel

This section describes the CICS TARGET PROFILE SELECTION panel.

The CICS TARGET PROFILE SELECTION panel has two areas. The first area, the Control Area, is explained in the MainView AutoOPERATOR Basic Automation Guide, Volume 2.

The second area of the panel contains a list of the target system names with defined profiles. You can define 23 targets. Unused slots read - OPEN -.

Figure 1. CICS target profile Selection panel

BMC Software ---------  TARGET PROFILE SELECTION  -----------   AutoOPERATOR
COMMAND ===>                                              TGT ===> CICSA
                                                           DATE --- YY/MM/DD
 Status Profiles are defined for these Target Systems. 
TIME --- 17:06:31 LINE COMMANDS: (S)elect, (D)elete
 LC   TARGET                     LC   TARGET              LC   TARGET
 --   CICSAOR                    __   - OPEN -            __   - OPEN -
 --   CICSTOR                    __   - OPEN -            __   - OPEN -
 --   CICSPROD                   __   - OPEN -            __   - OPEN -
 --   CICSTEST                   __   - OPEN -            __   - OPEN -
 --   CICSBASE                   __   - OPEN -            __   - OPEN -
 --   - OPEN -                   __   - OPEN -            __   - OPEN -
 --   - OPEN -                   __   - OPEN -            __   - OPEN -
 --   - OPEN -                   __   - OPEN -            __   DEFAULT

Use the following line commands in the LC column of this panel.

Command

Description

S

selects this open slot for use by the CICS target name shown in the TARGET fields

The open slot will be replaced by a slot bearing the current system name.

D

makes the indicated system profile slot available for use by deleting its current contents

Was this page helpful? Yes No Submitting... Thank you

Comments