Using MainView AutoOPERATOR Access NV

This section introduces the MainView AutoOPERATOR Access NV product option.

MainView AutoOPERATOR Access NV bridges the functional gap between the IBM NetView product and the BMC Software MainView AutoOPERATOR product. MainView AutoOPERATOR Access NV builds a pipeline that provides direct communication between NetView and MainView AutoOPERATOR which means that NetView and MainView AutoOPERATOR can send, retrieve, and act upon information between them.

The pipeline is structured in two major areas:

  • an automation pipeline that provides interaction and exchange between NetView and MainView AutoOPERATOR variables and automation procedures

  • a user-interface pipeline that is a NetView emulator in MainView AutoOPERATOR

    The emulator enables you to access line mode commands. NetView access can be from a TSO, ISPF, VTAM, or EXCP terminal session.

MainView AutoOPERATOR Access NV also provides the following types of events to the Rule Processor for automation:

  • NetView command events (NVC)

  • NetView messages events (NVM)

Refer to the MainView AutoOPERATOR Basic Automation Guide, Volume 1: Using Rules for more information.

Was this page helpful? Yes No Submitting... Thank you

Comments