TAPE STATUS Control panels

The data display area shows tape drives and their status.

The information is similar to the output of the MVS Display Unit command. Here, the information is in a scrollable list from which you can select devices with the desired characteristics, using simple commands. Device status is shown in three columns.

Figure 1. TAPE STATUS/Control panel

BMC Software --------------- TAPE STATUS/Control ----------------  AutoOPERATOR
COMMAND ===>                                                TGT ===> SYSB
INTERVAL ==> 3                                              DATE --- YY/MM/DD
STATUS   --- INPUT                                          TIME --- 10:34:00
LC CMDS  --- (ON)line, (OF)fline, (UNL)oad
LC  CUA  VOLUME  TYPE   JOBNAME VOLSTATE  ----------- STATUS -----------
___ 480           3400  CWB1TAPE     /REMOV ONLINE
___ 481           3400  CWB2TAPE     /REMOV ONLINE
___ 482   34055   3400  CIABKUP  PRIV/RESVD ALLOCATED
___ 483   20056   3400  QA2BOMT  PRIV/RESVD ALLOCATED
___ 484           3400  CMF16        /REMOV ONLINE
___ 485           3400  CMF24        /REMOV ONLINE
___ 486   02003   3400  DLYDCS   PRIV/RESVD ALLOCATED
___ 487  100304   3400  CWB1PRNT PRIV/RESVD ALLOCATED
___ 488   34579   3400  TCC2A    PRIV/RESVD ALLOCATED
___ 489   37803   3400  TW24AB   PRIV/RESVD ALLOCATED
___ 48A           3400               /REMOV OFFLINE     NOT RDY
___ 48B           3400               /REMOV OFFLINE     NOT RDY
___ 48C           3400               /REMOV OFFLINE     NOT RDY
___ 48D           3400               /REMOV OFFLINE     NOT RDY
___ 48E           3400               /REMOV OFFLINE     NOT RDY
___ 48F           3400               /REMOV OFFLINE     NOT RDY
___ 490           3400               /REMOV OFFLINE     NOT RDY
___ 491           3400  CWBTPBKP PRIV/RESVD ALLOCATED   CHG STAT  DDR PNDG

The data display area shows tape drives and their status. The information is similar to the output of the MVS Display Unit command. Here, the information is in a scrollable list from which you can select devices with the desired characteristics, using simple commands. Device status is shown in three columns.

You can use line commands to alter device status just as if they had been issued at the operator's main console. There are two types of line commands: MainView AutoOPERATOR and SYSPROG line commands.

TAPE STATUS Control panels

Comments