(optional) Step 6. Sending events to a BMC Impact Manager cell
Note
This panel appears only if you have specified PRODUCT=IIZ in BBPARM member BBISSP00.
For more information about customization steps that must be completed to send MainView AutoOPERATOR events to a BMC Impact Manager cell, refer to Chapter 19, 'Implementing the MainView AutoOPERATOR Interface to BMC Impact Manager' in the MainView AutoOPERATOR Customization Guide.
Use this panel to:
-
specify event data that the Rule sends to a BMC Impact Manager cell or other BMC products with a cell adaptor
Any event type can be sent to a BMC Impact Manager cell or other BMC products with a cell adaptor except IBM MQ non-event type messages. IBM MQ instrumentation events can be sent.
-
specify whether the Rule write event diagnostic information to the BBI Journal
-
specify targets to the send the event to
-
specify a new class name to be associated with the slots and values
-
specify a severity to be associated with the event
-
specify a component alias for event correlation against objects in the Service Impact Model (SIM)
For information about fields on this panel, refer to Event Action — BEIM fields.
The following figure shows an example of the panel for the event type MSG.
Figure 1. Event Action - BEIM panel
BMC Software -------------- Event Action - BEIM - MSG ---------- AutoOPERATOR
COMMAND ===> TGT --- AOAO
Rule-set === AAORULJO Rule-id === BIAGIOLI
Send Event ===> (Y|N)
Journal Details ===> (Y|N)
Target(s) ===>
Event Class ===> MV_EVENT_MSG
Severity ===>
(UNKNOWN, OK, INFO, WARNING, MINOR, MAJOR,
CRITICAL) (Default=WARNING)
Component Alias ===>
Event Slot Slot Value
_________________________________ ______________________________________
_________________________________ ______________________________________
_________________________________ ______________________________________
_________________________________ ______________________________________
_________________________________ ______________________________________
_________________________________ ______________________________________
_________________________________ ______________________________________
_________________________________ ______________________________________
Press ENTER or END to continue, or CANCEL to cancel changes.
Comments
Log in or register to comment.