Implementing MainView AutoOPERATOR Access NV

This section describes how to install the MainView AutoOPERATOR Access NV option into NetView and how to define the default NetView system to MainView AutoOPERATOR.

To implement the MainView AutoOPERATOR Access NV option to NetView and define the default NetView system to MainView AutoOPERATOR, you must complete the steps in the following table.

Task description

Reference

Modify NetView JCL

Modifying NetView JCL

Create member NAIOPT00 in the NetView DSIPARM data set

Creating DSIPARM member NAIOPT00

Create user-modifiable copies of the IBM DSIPARM members DSICMDU, DSIDMNU, and DSIOPFU

Make copies of these members for your PAS.

Modify DSIPARM member DSICMDU

Modifying DSIPARM member DSICMDU

Modify DSIPARM member DSIDMNU

Modifying DSIPARM member DSIDMNU

If you are using NetView 5.1, modify DSIPARM member CNMSTYLE

Modifying DSIPARM member CNMSTYLE

Copy members NAIINIT and NAISVAR into the NetView DSICLD data set

Copying BBSAMP members to the NetView DSICLD data set

Modify member DSIOPFU in DSIPARM

Modifying DSIPARM member DSIOPFU

Verify operator profiles

Verifying operator profiles

Review NetView security for Access NV operator IDs

Reviewing NetView security for Access NV operator IDs

Review use of DSIEX02A exit

Reviewing the use of NetView exit DSIEX02A

Review use of DSIEX03 exit

Reviewing the use of NetView exit DSIEX03

Review use of DSIEX14 exit

Reviewing the use of NetView exit DSIEX14

Review use of DSIEX16 exit

Reviewing the use of NetView exit DSIEX16

Modify member BBISSP00 in the BBPARM data set

Modifying BBPARM member BBISSP00

Restart NetView to implement JCL and parameter changes

Perform the restart.

Rrstart the BBI-SS PAS to implement parameter changes

Restart the PAS.




Was this page helpful? Yes No Submitting... Thank you

Comments