×
 
 
  •  
$helper.renderConfluenceMacro('{bmc-global-announcement:$space.key}')
MainView AutoOPERATOR 8.2 ... MainView AutoOPERATOR Customization Guide Implementing Automatic Restart Manager (ARM)

Enabling ARM support

To enable ARM support, edit the BBPARM member BBISSP00 and specify

ARMPOLCY=[NO|YES|xxxxxxxx]

where valid values are

  • NO: specifies that the BBI-SS PAS will not use the ARM facility; the default setting

  • YES: specifies that the BBI-SS PAS will use the ARM default restart policy

    The default ARM restart policy is that ARM will restart an abended address space up to three times within five minutes. If the address space fails to restart after the third attempt, a message is written to the SYSLOG and the address space remains unstarted.

  • xxxxxxxx: Specifies a 1- to 8-character name of a user-created policy to be used to control BBI-SS PAS restarts

When you have completed modifying the ARMPOLCY parameter, restart the BBI-SS PAS. Either a warm start or a cold start will cause the new ARM policy to be recognized.

The MainView Customization Reference describes how to implement ARM support during manual customization.

This version of the documentation is no longer supported. However, the documentation is available for your convenience. You will not be able to leave comments.

Last modified by Margaret Yen on Dec 08, 2018

Comments

Log in or register to comment.

Implementation considerations for ARM
Stopping MainView AutoOPERATOR when ARM is enabled
© Copyright 2013 - 2018 BMC Software, Inc.
Legal notices

Powered by Atlassian Confluence and Scroll Viewport

© Copyright 2005-2024 BMC Software, Inc. Use of this site signifies your acceptance of BMC’s Terms of Use . BMC, the BMC logo, and other BMC marks are assets of BMC Software, Inc. These trademarks are registered and may be registered in the U.S. and in other countries.