DASD STATUS-CONTROL application

The DASD STATUS/CONTROL application reports the status of Direct Access Storage Devices (DASD) in the target system specified, and allows the operator to modify the status.

The data display area lists DASD devices showing volume and status information. This information is similar to the output of the MVS Display Unit command. Here, the information is in a scrollable list from which you can select devices with desired characteristics, using simple commands.

Figure 1. DASD STATUS/CONTROL panel

BMC Software --------------- DASD STATUS/CONTROL ----------------  AutoOPERATOR
COMMAND ===>                                                TGT ===> SYSA
INTERVAL ==> 3                                              DATE --- YY/MM/DD
STATUS   --- INPUT                                          TIME --- 10:34:05
LC CMDS  --- (ON)line, (OF)fline, (UNL)oad
LC  CUA  VOLUME  TYPE     USERS VOLSTATE   ----------- STATUS ----------
___ 240  CMF001  3380        37 PRIV/RSDNT ALLOCATED   BUSY      RESERVED
___ 241  IMF007  3380        10 PRIV/RSDNT ALLOCATED   BUSY
___ 242  PMG006  3380        47 PRIV/RSDNT ALLOCATED             DDR PNDG
___ 243  TSG001  3380        77 PRIV/RSDNT ALLOCATED
___ 248  MSC001  3380         0 PRIV/RSDNT ONLINE
___ 249  PMG005  3380         8 PRIV/RSDNT ALLOCATED
___ 24A  DAV001  3380        13 PRIV/RSDNT ALLOCATED    BUSY
___ 24B  PMG004  3380         3 PRIV/RSDNT ALLOCATED
___ 250  IMF006  3380        51 PRIV/RSDNT ALLOCATED
___ 251  CMF002  3380        29 PRIV/RSDNT ALLOCATED
___ 252  DAV002  3380        49 PRIV/RSDNT ALLOCATED
___ 253  SYSMCA  3380         5 PRIV/RSDNT ALLOCATED    BUSY
___ 254  IMF004  3380        36 PRIV/RSDNT ALLOCATED
___ 255  SYSP1A  3380         6 PRIV/RSDNT ALLOCATED
___ 258  CMF004  3380        10 PRIV/RSDNT ALLOCATED
___ 259  CMF003  3380         3 PRIV/RSDNT ALLOCATED
___ 25A  IMF005  3380        30 PRIV/RSDNT ALLOCATED
___ 25B  IMF013  3380         0 PRIV/RSDNT ALLOCATED
      ******************** END OF DASD DEVICE **********************

Device status is shown in a three-part column. You can issue line commands to alter device status. These commands are executed just as if they had been issued at the operator's main console.

Was this page helpful? Yes No Submitting... Thank you

Comments