DataStore commands
The following figure shows the Energizer Commands - DataStores panel:
Energizer Commands - DataStores
Connect ________ + or Host ___________________________ Port _____
Select one of the following Energizer Commands. Then press Enter.
_ 1. -Display DS Type(Status) Id(*) DataStore. . * +
2. -Display Router Type(DS) Id(*)
3. -Display Stats Summary(DS) Id(*)
4. -Reset Stats Type(DS) Id(*)
5. -Set Router Type(DS) Id(*) State(Active)
6. -Set Router Type(DS) Id(*) State(Inactive)
7. -Set Router Type(DS) Id(*) Load(*) New Weight . (0-100)
Connect ________ + or Host ___________________________ Port _____
Select one of the following Energizer Commands. Then press Enter.
_ 1. -Display DS Type(Status) Id(*) DataStore. . * +
2. -Display Router Type(DS) Id(*)
3. -Display Stats Summary(DS) Id(*)
4. -Reset Stats Type(DS) Id(*)
5. -Set Router Type(DS) Id(*) State(Active)
6. -Set Router Type(DS) Id(*) State(Inactive)
7. -Set Router Type(DS) Id(*) Load(*) New Weight . (0-100)
To issue a command, perform one of the following actions:
- Type the number of the command, and press Enter.
- To issue a command against specific datastores, enter the datastore name, press the PROMPT key, or a enter a pattern.
Tip: For faster searching, add an asterisk to the end of your partial query. Example: cert*