The PATROL for UNIX and Linux 9.13.20.01 patch corrects issues reported in earlier versions of PATROL for UNIX and Linux. This topic contains information about fixes in this patch and provides instructions for downloading and installing the patch.
For information about issues corrected in this patch, see Known and corrected issues.
Select and download the installation files for your platform; see the following table. Use your BMC Support credentials to access the EPD website. You might also be prompted to complete the Export Compliance Form.
Component | EPD link | Installation file name |
---|---|---|
PATROL for UNIX and Linux (9.13.20.01) | Download link | All Platforms - puk_ALL_9132001.tar |
PATROL Installation Utility 10.7.00 | Download link | All Platforms - ins_ALL_10700.tar |
Note
Before you install the patch, you must have previously installed PATROL for UNIX and Linux 9.13.20. The patch does not contain all of the files that are required for a complete product release.
You must install the patch on the following computers:
Before you install the patch, complete the following steps:
Back up the PATROL_HOME/lib/knowledge and PATROL_HOME/lib/psl directories.
After you have downloaded the installation utility and patch files, perform the following steps to install the patch:
Extract the installation utility.
Enter tar -xvf ins_ALL_10700.tar. The contents of the files are extracted into the bmc_products subdirectory.
From the bmc_products directory, run the installation utility. Run setup.sh
Follow the on-screen instructions until the Select Products and Components to Install page is displayed.
On the Select Products and Components to Install page, select PATROL Knowledge Module for UNIX and Linux - Patch 9.13.20.01.
Follow the on-screen instructions to complete the installation.
After you complete the installation steps, you can delete the temporary directory and its contents.