• Spaces
  • People
  • Help
    • BMC Support Central BMC Community BMC.com
    ×
    BMC Change Automation 2.0

    Page tree
    Skip to end of metadata
    Go to start of metadata

    After BMC Change Automation is successfully installed, perform the following postinstallation procedures:

    StepInstruction
    Steps to perform in BMC Atrium Orchestrator
    In case of fresh installation of BMC Atrium Orchestrator version 7.9, verify whether BMC Atrium Orchestrator is installed successfully.
    • Log on to the Grid Manager using the appropriate URL:
    ProtocolURL
    HTTPhttp://FullyQualifiedDomainName:CDPWebServerPort/baocdp
    HTTPShttps://FullyQualifiedDomainName:CDPWebServerPort/baocdp
    • Log on to the Repository Manager using the appropriate URL:
    ProtocolURL
    HTTPhttp://FullyQualifiedDomainName:repoWebServerPort/baorepo
    HTTPShttps://FullyQualifiedDomainName:repoWebServerPort/baorepo

     

    For more information, see Logging into Grid Manager and Repository Manager in the BMC Atrium Orchestrator Platform 7.9 online documentation.

    Verify that the required BMC Atrium Orchestrator modules are activated and adapters are enabled.
    • Verify whether the BMC-SA-CLA_ITSM_Integration module is added to the Repository Manager:

    • Verify whether the following adapters are enabled:

    • Verify whether the following modules are activated:

    For more information, see Enabling and disabling adapters and Activating modules in the BMC Atrium Orchestrator Platform 7.9 online documentation.

    Steps to perform in BMC Server Automation
    Enable configuration of BMC Change Automation in BMC Server Automation

    Ensure that connection details of BMC Atrium Orchestrator and BMC Remedy IT Service Management are correctly configured and BMC Change Automation is enabled in BMC Server Automation.


    For information about configuring these connection details, see Enabling BMC Change Automation in BMC Server Automation. 

    Review results of one-click validation testCheck validation errors with results of one-click validation test and resolve the errors, if any.
    See Validating integrations. 
    (Optional) Manually run the one-click validation utility

    After resolving all the errors, manually re-run the one-click validation utility again to ensure that there are no more errors and that all integration validation tests pass successfully.  See Manually running the one-click utility.

    Where to go from here

    Enabling Operator-Initiated Change

    Enabling Change-Initiated Job

    © Copyright 2005-2021 BMC Software, Inc. Use of this site signifies your acceptance of BMC’s Terms of Use . BMC, the BMC logo, and other BMC marks are assets of BMC Software, Inc. These trademarks are registered and may be registered in the U.S. and in other countries.