Page tree

Unsupported content

   

This version of the documentation is no longer supported. However, the documentation is available for your convenience. You will not be able to leave comments.

Skip to end of metadata
Go to start of metadata

Verifying the BMC TrueSight Capacity Optimization instance consists of the following:

  1. Verify the BMC TrueSight Capacity Optimization services are running
  2. Verify the BMC TrueSight Capacity Optimization console is working

Before you begin

Before you begin verifying the BMC TrueSight Capacity Optimization instance, you must complete Installing Application Server and components or Upgrading Application server and components.

To verify that BMC TrueSight Capacity Optimization services are running

  1. Verify all BMC TrueSight Capacity Optimization services are running:
    1. At $CPITBASE, type ./cpit status.
      A list of installed BMC TrueSight Capacity Optimization services and their current status is displayed.
      Example of a list of running BMC TrueSight Capacity Optimization services
    2. Verify that all installed BMC TrueSight Capacity Optimization services are RUNNING. The following table lists BMC TrueSight Capacity Optimization components and the services that correspond to each:

      Component

      Web service

      Scheduler service

      Service Container service

      Data Hub service

      Httpd service

      Web

      (tick)

      (tick)

      (tick)

       

      (tick)

      Primary Scheduler

       

      (tick)

      (tick)

       

       

      Data Hub

       

      (tick)

      (tick)

      (tick)

      (tick)

      ETL

       

      (tick)

       

       

       

       

      For example, if you have installed a Primary Scheduler and the Data Hub, verify that the Scheduler, and Data Hub services are RUNNING.

  2. To stop all installed BMC TrueSight Capacity Optimization services, type ./cpit stop.
  3. Verify all installed BMC TrueSight Capacity Optimization services are stopped:
    1. Type ./cpit status.
      A list of installed BMC TrueSight Capacity Optimization services and their current status is displayed.
    2. Verify that all installed BMC TrueSight Capacity Optimization services are STOPPED.
  4. To restart all installed BMC TrueSight Capacity Optimization services, type ./cpit start.
  5. Verify all installed BMC TrueSight Capacity Optimization services are running (see step 1).

To verify the BMC TrueSight Capacity Optimization Console works properly

  1. Open a compatible browser.
  2. Go to http://<host>:8000/console or https://<host>:8443/console (for HTTP Secure), where <host> is the computer or virtual machine on which you installed BMC TrueSight Capacity Optimization.
    For example, http://xenvm-rh52.domain.com:8000/console or https://xenvm-rh54.domain.com:8443/console (for HTTP Secure).
  3. Verify that the BMC TrueSight Capacity Optimization Console is displayed, and then log on with the following credentials:
    Username: admin
    Password: admin

    Note

    One user account, admin, is built in to BMC TrueSight Capacity Optimization. The default password for the admin user account is admin. BMC recommends changing the password for admin immediately after installation. For information about how to change the password for a user account, see  Accounts.

  4. Verify that the Welcome page is displayed.

    Additional information

    A message is displayed if the date and time of the application server server and database are not in sync. You must sync the date and time on both the servers.

  5. Navigate to Administration > SYSTEM > Status.
    The Components status table is displayed, that lists the status of the BMC TrueSight Capacity Optimization components.
  6. Verify that the status for all components listed is OK.

Where to go from here

After you verify that the typical BMC TrueSight Capacity Optimization installation is successful, continue with Configuring after install.