You must configure the direct memory access (DMA) of the monitored network interface card (NIC) if you are installing the Real User Cloud Probe:.
Typically, you will have to increase the receive (RX) and transfer (TX) ring buffer sizes on the NIC to accommodate a high traffic volume. You will also need to set the card to send all traffic to the CPU.
Run the ifconfig
command to see a list of the NICs on the system.
Increase the buffer settings on the ethernet card by running the following ethtool
commands:
>ethtool -G eth<X> rx 4096 >ethtool -G eth<X> tx 4096
Replace eth<X>
with the network interface card that is configured for the Cloud Probe, such as eth0
or eth1
.
Send all NIC traffic to the CPU by setting the promisc
mode on the configured network interface:
>ifconfig eth<X> promisc
Replace eth<X>
with the network interface card that is configured for the Cloud Probe, such as eth0
or eth1
.
Note
The Promiscuous mode is not mandatory when using Cloud Probe. For example, the promiscuous mode is not needed if the traffic you need to capture is being sent to the same system where the Cloud Probe is installed. For more information on the Cloud Probe deployment, see Cloud Probe deployment use cases.
System requirements for Cloud Probe