Router Options commands
This topic describes router options commands.
The Energizer Commands Router panel lists commands that are used display and set router options.
Related topic
The following figure shows the Energizer Commands - Router panel:
Energizer Commands - Router
Connect ________ + or Host ___________________________ Port _____
Select one of the following Energizer Commands. Then press Enter.
__ 1. -Display Router Type(Status)
2. -Display Router Type(Affinity)
3. -Set Router Type(Options) Lbmgt(Active)
4. -Set Router Type(Options) Lbmgt(Inactive)
5. -Set Router Type(Options) Afmgt(Active)
6. -Set Router Type(Options) Afmgt(Inactive)
7. -Set Router Type(Options) RdbMemb(*) New Router Member
8. -Set Router Type(Affinity) State(Act) Id(*) Affinity Label. .
9. -Set Router Type(Affinity) State(Inact) Id(*) ' '
10. -Set Router Type(Affinity) Id(*) Dest(*) DataStore Dest. .
To issue a command, perform one of the following actions:
Type the number of the command, and press Enter.
To issue a command against a specific router member, Affinity Label, or DataStore Destination, enter the information on the lines provided.
Was this page helpful? Yes No
Submitting...
Thank you
Comments
Log in or register to comment.