Verifying the BMC Digital Workplace installation
This topic describes basic steps to verify that the BMC Digital Workplace installation completed.
Before you begin
Complete the installation as described in Performing the BMC Digital Workplace installation.
To verify the installation
Perform the following checks:
- Check the Services and ensure that the application service is running. For Windows, this service is DWP Application. For Linux, this service is DWPApplication.
Go to http://server:port/dwp/admin and log on using BMC Digital Workplace Administrator credentials.
server is the host name or IP address of the BMC Digital Workplaceserver, and port is the port defined for the administration console during installation.
- For Linux, the installer registers the following service:
- DWPApplication
- For Windows, the installer registers the following service:
- DWP Application
Where to go from here
After you verify the installation, continue with Configuring after installation of BMC Digital Workplace.
Was this page helpful? Yes No
Submitting...
Thank you
Comments