Installing the package to launch the UI installer (on Linux)
Before you can run the UI installer on Linux, a system administrator must install required packages. This task is part of the procedures described in Preparing for installation of BMC Digital Workplace.
Before you begin
If you are running as a non-root user, see Requirements for a non-root user to run the installer.
To install the required packages
Use the following commands to install the package:
yum install compat-libstdc++-33 libX11.i686 libXau.i686 libxcb.i686 libXext.i686 libXi.i686 libXtst.i686 libstdc++.so.5 libstdc++.so.6
yum install libXrender
yum install libstdc++
Where to go from here
Was this page helpful? Yes No
Submitting...
Thank you
Comments
Log in or register to comment.