Starting and stopping the UIM server
To start and stop the UIM server, you must issue MVS operator commands on the host that the UIM server is installed on.
To start the UIM server
Issue the following MVS operator command, where uimServerName is the name of the UIM server started task:
/S <uimServerName>
To stop the UIM server
Issue the following MVS operator command, where uimServerName is the name of the UIM server started task:
/P <uimServerName>
Important
To avoid data loss, notify active users if you must stop the UIM server.
Related topic
Was this page helpful? Yes No
Submitting...
Thank you
Comments
Log in or register to comment.