Inactivating XIM initiators
You can use the QUIESCE command to prevent additional work from being accepted. Work that is in progress is allowed to finish. Typically, you would issue this command before shutting down XIM.
To inactivate the initiators
To inactivate the XIM initiators, issue the following command: /F XIMACM,QUIESCE
An excerpt from the system log shows the result of issuing the QUIESCE command:
BMC95100I XIM QUIESCE Command Accepted, XIM QUIESCE in progress XIMACM
BMC95100I XIM STOP Command Accepted, Initiator termination in progress
BMC98522I Initiator shutdown request received in ASID(01F6). XJS1
BMC98212I XJS initiator ended in ASID(01F6). XJS1
Important
The XIM initiators are inactivated only on the image on which you issued the QUIESCE command. If more than one image is participating in a group, issue the QUIESCE command on each image.
Related topic
Was this page helpful? Yes No
Submitting...
Thank you
Comments
Log in or register to comment.