Unsupported content

 

This version of the documentation is no longer supported. However, the documentation is available for your convenience. You will not be able to leave comments.

Creating network containers

A network container is a data object that provides network isolation for tenants in the cloud. You must create and onboard a pod before you create a network container. You must have at least one network container in a pod. If you have multiple tenants, you might want to create a network container for each tenant. See Network resources overview for more information.

Note

If a network container is shared across multiple tenants, then the Network tab in the Resource Management workspace is not visible to Tenant Admins. Therefore, the Tenant Admins would not be allowed to edit firewall rules and network paths, and would not be able to manage load balancers.

The configuration of a network container is specified in a network container blueprint. Network container blueprints are created in BMC Network Automation, as described in Creating network container blueprints.

You must create at least one network container in BMC Cloud Lifecycle Management.

Before you begin

To create a new network container

To create a new network container, you launch a wizard that contains three dialog boxes. In the first dialog box, you specify the unique name of the container, its pod, network container blueprint, NAT range (if applicable), and any tags. In the second dialog, you specify networks, firewalls, and associated load balancers. In the third dialog, you enter any additional parameters.

  1. From the BMC Cloud Lifecycle Management Administration Console, click the vertical Workspaces menu on the left side of the window and select Resources.
  2. Under Quick Links on the left, click Network Containers under the Network section.
  3. Click the Create Network Container icon .
    The Create Network Container wizard is displayed.


  4. Complete the following fields:

    Field

    Description

    Name

    Required. Enter a unique name.

    Description

    Provide a description that helps to distinguish this container.

    Tags

    Metadata that helps to define and classify the network container. Click the Add Tag icon to open the Tag Details dialog box from where you select or add a tag. See Creating tag groups and tag.

    Pod

    Select an appropriate pod from the list of available ones.

    Container Blueprint

    Select a network container blueprint from the list of available ones. The selection of the network container blueprint determines whether the container is dynamic and whether it supports Network Address Translation.

    NAT Address Pools

    This table shows the pools of registered IP addresses to which Network Address Translation can map an unregistered IP address. This section is enabled if the selected container blueprint supports Network Address Translation.

    Add NAT Address Pools

    Use the following fields to add a new NAT Address Pool:

    • Address — Enter a single IP address to identify the starting point of the address range.
    • Mask — 24- or 32-bit mask that divides the IP address into subnets and identifies the available hosts in the network.
      Click Add to add the new NAT Address Pool. The Address in combination with the Mask defines the address range to be allocated for the network container. These fields are enabled if the selected container blueprint supports Network Address Translation.
  5. Click Next to open the Dynamic Components dialog box. It displays the available networks and corresponding load balancers. See Managing dynamic components for network containers.

The container will be provisioned on the network by BMC Network Automation using the specified network container blueprint.

    MultiExcerpt named 'pendingacts' was not found
The multiexcerpt named 'pendingacts' was not found. Please check the page name and MultiExcerpt name used in the MultiExcerpt Include macro.

After the activity is marked as complete, you can click the Refresh icon in the upper-right corner of the window to refresh the Resources table so that the newly created network containers appear in the list of network containers.

Where to go from here

To continue with the next step of the wizard when creating or editing a network container, see Managing dynamic components for network containers.

You can now:

To view, create, or update network paths, see Managing network paths.

Was this page helpful? Yes No Submitting... Thank you

Comments