Filtering for specific diagnostic results

If you have executed many tests, the results table can be quite long. Above the table, two list boxes are available that provide you the possibility to filter and thus reduce the number of entries in the results table. To filter the table according to a specific result, proceed as follows:

  • In the box Diagnostic Result select the status to which you want to limit the list to:
    • All to display all executed diagnostics.
    • Failed to display all diagnostics of which at least one test failed.
    • Diagnostic Init Failure to display only diagnostics of which at least one test could not be initialized.
    • Successful to display only diagnostics that completed successfully.
    • Aborted to display only diagnostics of which the execution was cancelled.

The list is immediately updated and will now only show the desired results.

Was this page helpful? Yes No Submitting... Thank you

Comments