Running debug mode on a Cloud Probe

When you experience problems with the Real User Cloud Probe, the Customer Support representative might ask you to run the Cloud Probe in debug mode and then send the logs.

Based on the log data, the Support representative will be able to locate the root cause of the problem.

To run debug mode on Linux

  1. Stop the BMC Real User Cloud Probe service.
  2. Start debug mode by running the following command:
    service cloud-probe start debug
  3. When the debug process is complete, stop debug mode by running the following command:
    service cloud-probe stop
  4. Start the BMC Real User Cloud Probe service to continue working.

To run debug mode on Windows

  1. Stop the BMC Real User Cloud Probe service.
  2. In the Cloud Probe installation folder, open the cloudprobe folder and run the create_cp_debug.bat file.
  3. Run the services.msc command and start the BMC Real User Cloud Probe Debug service.
  4. When the debug process is complete, stop the BMC Real User Cloud Probe Debug service.
  5. (Optional) Remove the debug service by running the delete_cp_debug.bat file located in the <InstallDir>\cloudprobe\ folder.
  6. Start the BMC Real User Cloud Probe service to continue working.
Was this page helpful? Yes No Submitting... Thank you

Comments

  1. Sabari Yadavilli

    Hi Team,

    There is big flaw in file names. Mentioned in the above document as, To enable the debug on cloud probe mentioned as run the create_cp_debug.bat.... it was for the old version but in the new version 11.0 (+) it is renamed as register_cloud_probe_debug_service.bat. can you please assure and update the details as per the new version.

    Regards SY

    Oct 24, 2019 03:41