mrmerge
Warning
This command is executed internally by the mrecover
CLI and must be manually executed only on the advice of BMC Support.
The mrmerge
command is one step in the cell recovery process. This command merges events recovered from other cells into a new, saved state for the local cell being recovered. For more information, see mrecover.
mrmerge syntax
The following figure shows the syntax for mrmerge
.
mrmerge syntax
mrmerge [-h|-?] [-c <ConfigFile>] [-l <HomeLocation>]
[-n <cellName> | -n @Host[/Port[#Key]]] {-p <"Var=Value">}
[-o <OutputFile>] {<InputFile>} [-q] [-z]
The following table lists the command-specific options for mrmerge
. For a list of common command options that apply to all CLI commands, see Event management common command options.
mrmerge options
Option | Description |
---|---|
| Specifies the file ( |
| Specifies the input file for the |
mrmerge example
The following figure shows an example of mrmerge
Example of mrmerge
mrmerge -n Cellone -o installationDirectory/pw/server/var/Cellone/mcdb/tmp/mcdb.X1 /tmp/mcdb.X2
mrmerge return codes
The following table lists the command-specific return codes for mrmerge
. For a list of common return codes that apply to all CLI commands, see Event management return codes.
mrmerge return codes
Code | Description |
---|---|
| Failed to enable tracing |
| Cannot access StateBuilder |
| Failure loading KB classes |
| Cannot start while StateBuilder is active |
Comments
Log in or register to comment.