Example procedure for verifying compliance results

Use the following procedure to verify the results of a Compliance Job.

  1. Expand the job run and choose either the Rules View or Server View node.

    An item in bold indicates that at least one of the checks on the target was noncompliant.
  2. Navigate to the relevant rule group and select it.
    A summary of results is displayed to the right.

  3. Navigate further to an individual rule.
    The rule definition is displayed. If a line is listed in red, this indicates that the check was noncompliant on the target server.
  4. Select a noncompliant (red) line in the rule definition.
    The result from the target is displayed below the rule definition.

After execution, a job enters one of the following statuses:

  • Pass
  • Warning
  • Fail
Was this page helpful? Yes No Submitting... Thank you

Comments