Job Optimizer commands
Job optimization requires processing from both the MainView Batch Optimizer Subsystem and Job Optimizer components. Commands provide control to these components and enable you to display status information about them. You can enter any of these commands from the operator console or from any facility that emulates an operator console.
This section provides the following topics:
- Overview of Job Optimizer Commands
- Starting the BMC Software Primary Subsystem - Job Optimizer
- Displaying the status of the BMC Software Primary Subsystem - Job Optimizer
- Stopping the BMC Software Primary Subsystem - Job Optimizer
- Canceling the BMC Software Primary Subsystem - Job Optimizer
- Determining the MainView Batch Optimizer Subsystem address space ID2
- Starting the MainView Batch Optimizer Subsystem - Job Optimizer
- Displaying the status of the MainView Batch Optimizer Subsystem - Job Optimizer
- Stopping the MainView Batch Optimizer Subsystem - Job Optimizer
- Canceling the MainView Batch Optimizer Subsystem - Job Optimizer
- Starting the Extended Job Execution Subsystem
- Displaying the status of the Extended Job Execution Subsystem
- Quiescing the Extended Job Execution Subsystem
- Stopping the Extended Job Execution Subsystem
- Reinitializing Job Optimizer
- Displaying the status of Job Optimizer
- Enabling and disabling Job Optimizer
- Quiescing Job Optimizer
- Displaying the status of a system in a BatchPlex
- Activating a job policy in Job Optimizer
- Displaying the status of a job policy
- Displaying the waiting status of job steps
- Determining a job definition location using a command
- Setting the default JTL action
- Activating a UCF definition
- Displaying the active UCF definition
- Specifying and listing active JES3 initiator groups
- Dumping MainView Batch Optimizer Subsystem information
- Capturing MainView Batch Optimizer Subsystem information
- Activating and stopping MainView Batch Optimizer Subsystem tracing
- Creating or modifying a trace table
- Controlling the Job Optimizer IEFACTRT exit
- Controlling the SCT with Job Optimizer
- Job Optimizer commands - Overview
- Activating the Subzero interface in MainView Batch Optimizer
Was this page helpful? Yes No
Submitting...
Thank you
Comments