Controlling the SCT with Job Optimizer
The BSL STEPNUM command controls whether the Section Control Table (SCT) for a split step contains step number 1 or is updated to reflect the actual step number.
To control the SCT
Enter the following command:
mbos BSL STEPNUM [ON | OFF]
Value | Description |
---|---|
ON | Reflects the actual step number |
OFF | Makes the step number in the SCT a 1 |
If you used Control-D to process SYSOUT for a split step, you must set STEPNUM to ON. BMC recommends that you place a BSL STEPNUM ON statement in your BatchPlex command member BCSCMD00.
Was this page helpful? Yes No
Submitting...
Thank you
Comments
Log in or register to comment.