Executing a silent upgrade
To launch the silent upgrade, you use the same command for all platform components. The options file controls which component is upgraded and its properties.
You execute silent upgrades from the command line and you are not prompted for input. On Red Hat Linux or Oracle Solaris operating systems, you can output debug logging to the console window by exporting LAX_DEBUG=true.
Before you begin
You must have an options file that specifies the components to upgrade and where to upgrade them.
Note
Check the Release notes and notices area for information about service packs, patches, and content versions that are available for BMC Atrium Orchestrator.
Review the information in Preparing for upgrade and ensure that you have performed required pre-upgrade steps.
If you run into any issues related to integrating with Atrium Single Sign-On or registering agents after an upgrade, see Troubleshooting BMC Atrium Single Sign-On problems for more information.
To execute a silent upgrade
- Navigate to the directory that contains the silent installation program.
From the command line, execute one of the following commands to start the silent installation program.
When you specify the options file name, specify the full path to the options file, not a path that is relative to the installation program.
Type the command carefully. If you type the command incorrectly, you might invoke an installation mode that is unsupported.Platform
Command
Server components
See Performing the installation for the component installation program names.
In the following component command lines, replace installCommand with the installation program name.Linux
sh ./installCommand
-i silent -DOPTIONS_FILE=fullPathToOptionsFile/optionsFile
Solaris
sh ./installCommand
-i silent-DOPTIONS_FILE=fullPathToOptionsFile/optionsFile
Windows
pathToInstaller\installCommand
-i silent-DOPTIONS_FILE=fullPathToOptionsFile\optionsFile
BMC Atrium Orchestrator Development Studio
Windows
pathToInstaller\setup.cmd
-i silent-DOPTIONS_FILE=fullPathToOptionsFile\optionsFile
Content
Linux
sh ./setup.sh
-i silent-DOPTIONS_FILE=fullPathToOptionsFile/optionsFile
Solaris
sh ./setup.sh
-i silent-DOPTIONS_FILE=fullPathToOptionsFile/optionsFile
Windows
pathToInstaller\setup.cmd
-i silent -DOPTIONS_FILE=fullPathToOptionsFile\optionsFileThe installer executes without prompts.
- As necessary for your environment, execute the silent installation on other computers until you have upgraded or installed all of the platform components.
Upgrade videos
The following BMC Communities video series demonstrates how to upgrade a basic setup of BMC Atrium Orchestrator Platform 7.6.03 to 7.8.01 and upgrading Content on Windows. Some instructions apply only to upgrading 7.6.03 to 7.8.01, but other parts of the upgrade videos apply to upgrading any BMC Atrium Orchestrator Platform and Content version.
Part one (7:29) in the silent upgrade series provides an overview of the new features in 7.8.01, highlights some important differences between 7.6.03 and 7.8.01, provides an overview of the upgrade steps and prerequisites, and demonstrates how to install Atrium Single Sign-On.
Part two (7:06) in the silent upgrade series demonstrates how to set up the repository and CDP upgrade option files and how to upgrade a repository.
Part three (6:25) in the silent upgrade series demonstrates how to upgrade a CDP, set up the BMC Atrium Orchestrator Content upgrade option file, and upgrade content.
Where to go from here
When you finish executing the silent installation to upgrade the CDP, clear your browser's cache before you begin using the upgraded components.
Comments
Log in or register to comment.