Post-installation tasks for the Microsoft Active Directory adapter

You can enable the Microsoft Active Directory application adapter on BMC Atrium Orchestrator peers running on a Microsoft Windows operating systems. In addition to enabling the adapter on a Windows peer, you must adjust the permission levels for the BMC Atrium Orchestrator service on that peer to allow the adapter to communicate properly.

Before you begin

Set the permissions for the BMC Atrium Orchestrator Application Adapter for Microsoft Active Directory when the adapter is in the default mode.

To set permissions for the BMC Atrium Orchestrator Application Adapter for Microsoft Active Directory

  1. On the peer on which the Microsoft Active Directory adapter is enabled, navigate to the Services window (Start => Control Panel => Administrative Tools => Services).
  2. From the Services page, right-click the BMC Atrium Orchestrator AP, BMC Atrium Orchestrator LAP, BMC Atrium Orchestrator CDP, or BMC Atrium Orchestrator HACDP service, and select Properties from the pop-up menu.
  3. Click the Log On tab, and then click the This account option.
  4. Type the username to be used for this service and the corresponding password for the user.

    Note

    The user must be able to communicate externally and use a communication interface.

  5. Click Apply, and then click OK.
  6. Restart the BMC Atrium Orchestrator AP, BMC Atrium Orchestrator LAP, BMC Atrium Orchestrator CDP, or BMC Atrium Orchestrator HACDP service.
Was this page helpful? Yes No Submitting... Thank you

Comments