Unsupported content

 

This version of the product has reached end of support. The documentation is available for your convenience. However, you must be logged in to access it. You will not be able to leave comments.

Before you begin installing the Discovery Synchronization run book

The following table lists those BMC Software products that must be installed and operating prior to implementing the run book. The list in the following table reflects the product versions that have been tested as compatible at the time of this release. For up-to-date information, see the product compatibility matrix on the Customer Support website at http://www.bmc.com/support.

Required software products

Product

Required version

Notes

BMC Atrium Discovery and Dependency Mapping

8.2

N/A

BMC Atrium Orchestrator

Content: 20.15.01

See Installing and configuring the Discovery Synchronization run book

Review Release notes and notices for updated information about this version. This section also contains information about flashes, service packs, and resolutions that were issued for this version after its release. To enable the solution, you must have installed version 7.6.03 or later of Access Manager and the repository, and both applications must be running.

The computer from which you run the installation program must have network access to the repository computer. 

The BMC Atrium Orchestrator Platform components provide the configuration distribution peer and the tools required for creating a grid. Installing the platform components is a prerequisite for installing BMC Atrium Orchestrator Content, which includes adapters, modules, and run books. 

The BMC Atrium Orchestrator Platform installation program enables you to install and configure the BMC Atrium Orchestrator CDP, BMC Atrium Orchestrator Operator Control Panel, graphing server, and Access Manager components. 

The platform installation program enables you to install components in a pre-existing web server environment or in a new web server.

Tip

BMC recommends installing the CDP component in a new web server environment to ensure good performance, unless you are upgrading a previously installed version.

To view the complete instructions for installing and configuring the BMC Atrium Orchestrator Platform components, see Installing. After the BMC Atrium Orchestrator Platform components are installed and running, configure a grid. The grid distributes information across the BMC Atrium Orchestrator components.


Was this page helpful? Yes No Submitting... Thank you

Comments